Multi-rail Gutter Kit Fitting Instructions

1- The metal above the doors need to be degreased and cleaned well with acetone! The gap below the circumference of the roof needs to be masked with adhesive tape. Mask the bodywork with plastic film (for protection chippings).

2- Attach the front end piece as shown on the picture; let the tip of it overlap approx 2mm.

Mark the complete contourwith a pencil or marker; the marking of the back of the end piece is beginning of the rail.

3- Attach the universal rail with its leading edge accurate to the marking and parallel to the car contour.

Mark both front drill holes.

Mark with a punch. Drill with the 3.2mm drill bit.

4- Screw the self tapping screws (3.9mm - 16mm) to the universal rail. Start where you pre-drilled the two front drill holes. Now fix on the rail from the front to the back. Take care! Make sure that it's parallel to the beading.

The space above the rail needs to be masked with adhesive type for protection. Now draw the contour of the back of the end piece.

5- Unscrew the rail. The surface under the rail and the two end pieces need to be roughened.

Clean the surface with acetone again. The drill holes need to be brushed with colour primer. Wait until the colour has dried. Also take note of the manufacturer's instructions.

6- Before applying sealant/adhesive on the cleaned surface, cut the end of the tube off at an angle at the second mark on the nozzle. hold the tube upside down vertically and apply the adhesive evenly.

Every drill hole needs to be sealed. Now screw on the rail using black screws (3.9mm).

Carefuly remove any surplus adhesive by using the special adhesive remover.

7- Attaching the end pieces:

The painted surfaces need to be cleaned and roughened. Pre-treat the surface by using adhesive promoter. After the primer has dried, apply some adhesive to the rail ending and to the first cm of the end piece. To extend the protective film of the end piece put some sellotape at the end of it - it will be easier to remove it later. The end pieces need to be applied at an angle. Remove the protective film carefully one cm at a time and press on the rail at the same time. Allow 24 hours to harden before use.

Rail fitted